Welcome to HANOI-SSE

Radiation cannot be detected by human senses. A variety of handheld and laboratory instruments is available for detecting and measuring radiation. The most common handheld or portable instruments are:

1.  Geiger Counter, with Geiger-Mueller (GM) Tube or Probe A GM tube is a gas-filled device that, when a high voltage is applied, creates an electrical pulse when radiation interacts with the wall or gas in the tube. These pulses are converted to a reading on the instrument meter. If the instrument has a speaker, the pulses also give an audible click. Common readout units are roentgens per hour (R/hr), milliroentgens per hour (mR/hr), rem per hour (rem/hr), millirem per hour (mrem/hr), and counts per minute (cpm). GM probes (e.g., "pancake" type) are most often used with handheld radiation survey instruments for contamination measurements. However, energy-compensated GM tubes may be employed for exposure measurements. Further, often the meters used with a GM probe will also accommodate other radiation-detection probes. For example, a zinc sulfide (ZnS) scintillator probe, which is sensitive to just alpha radiation, is often used for field measurements where alpha-emitting radioactive materials need to be measured. 
   
2. MicroR Meter, with Sodium Iodide Detector A solid crystal of sodium iodide creates a pulse of light when radiation interacts with it. This pulse of light is converted to an electrical signal by a photomultiplier tube (PMT), which gives a reading on the instrument meter. The pulse of light is proportional to the amount of light and the energy deposited in the crystal. These instruments most often have upper and lower energy discriminator circuits and, when used correctly as single-channel analyzers, can provide information on the gamma energy and identify the radioactive material. If the instrument has a speaker, the pulses also give an audible click, a useful feature when looking for a lost source. Common readout units are microroentgens per hour (μR/hr) and/or counts per minute (cpm). Sodium iodide detectors can be used with handheld instruments or large stationary radiation monitors. Special plastic or other inert crystal "scintillator" materials are also used in place of sodium iodide. 
   
3. Portable Multichannel Analyzer A sodium iodide crystal and PMT described above, coupled with a small multichannel analyzer (MCA) electronics package, are becoming much more affordable and common. When gamma-ray data libraries and automatic gamma-ray energy identification procedures are employed, these handheld instruments can automatically identify and display the type of radioactive materials present. When dealing with unknown sources of radiation, this is a very useful feature.